Outside Back Exhaust (Horizontal Duct); C1. Adapting The Microwave Blower For Outside Back Exhaust - Samsung SMH2117S Installation Instructions Manual

Step-by-step installation guide
C. OUTSIDE BACK EXHAUST (HORIzONTAL DUCT)
C1. ADAPTING THE mICROWAVE
BLOWER FOR OUTSIDE BACK
EXHAUST
1. Remove and save the screws that hold the
Blower Plate to the microwave.
Screw
Blower Motor
3. Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
BEFORE: Fan Blade
Openings Facing Forward
End A
CAUTION: To avoid breaking or cracking the blower
blade, do not touch the blade. Hold the outer case
of the blower when you pull it out or put it back in
place.
4. Remove Parts "A" with tin snips or pliers.
Parts "A"
SMH1816_XAC_DE68-03943B-01_EN_120725.indd 14
2.
Lift up the
Blower plate.
Back of microwave
Blower Plate Screw
End B
5. Rotate the blower unit counterclockwise 180 °.
Before Rotation
Back of microwave
6. Place the blower unit back into the opening.
AFTER: Fan Blade Openings
Facing Back
End B
CAUTION: Do not pull or stretch the blower unit
wiring. make sure the wires are not pinched.
NOTE: The blower unit exhaust openings
should match exhaust openings on the rear of
microwave oven.
7. Close the Blower Plate and attach the exhaust
adaptor to the rear of the oven by sliding it into
the guides at the back top center of the oven.
Push in securely until it is in the lower locking
tabs. Take care to ensure that the damper hinge
is installed so that it is at the top and that the
damper swings freely.
Adaptor
Guide
From Blower motor screw
(after attached the exhaust adaptor)
14
After Rotation
Back of microwave
End A
Back of
Microwave
Guide
Locking Tabs
2012-07-25 7:50:51
3.
IN
A.
B.
C
D
E.
A
Yo
ou
•
•
•
C
yo
no