Toshiba PSA10C-00REH User Manual page 119

3. Use the left/right cursor keys to highlight the boot device you want
and press Enter.
A menu change bar does not appear when a supervisor password is set
and Permit to use HW Setup or BIOS SETUP in TOSHIBA Password
Utility is not checked by the user intentionally, and the PC is booted under
the control of the user including the case that the user password is not
registered.
The selection method above does not change the boot priority settings in
HW Setup.
If you press a key other than one of those above or if the selected device
is not installed, the system will boot according to the current setting in HW
Setup.
Support of PDA (ATA) card boot is guaranteed only for TOSHIBA PC card
HDDs.
A PDA (ATA) card takes the position of HDD in the Boot Priority Options
list.
HDD Priority Options
If more than one HDD is installed in the computer, this option lets you set
the priority for HDD detection. If the first detected HDD has a boot
command, the system will boot from the HDD.
Built-in HDD ->
PC Card (Default)
PC Card -> Built-
in HDD
If a boot command is not found on the first detected HDD, the system will
not boot from the other HDD. It will search the next device in the boot
priority for a boot command.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE]
[RPL]
The Wake-up on LAN function consumes power even when the system is
off. Leave the universal AC adaptor connected while using this feature.
Satellite Pro A10 Series
HDDs are searched for a boot command in the
following order: the built-in HDD, and the PC
card. (Default)
HDDs are searched for a boot command in the
following order: the built-in HDD and the PC
card.
Sets PXE as the protocol. (Default)
Sets RPL as the protocol.
HW Setup and Passwords
7-7