D-Link DFE-2624 - Hub - Stackable User Manual page 13

Link Test Function State
disabled . If enabled, the port will check for link pulses, and will only transmit if
there is a good link to another station.
Administration State
disabled .
Port Speed State
or 100Mbps .
Generate Trap When Link State Change Indicates whether or not the port will
send a trap if it's link status changes.
Generate Trap When Speed State Change
will send a trap if it's speed changes.
Reset
Doing a remote reset is equivalent to turning the hub off and on again. All parameters
are returned to the values stored in EEPROM.
RESET
Click to reset the Hub.
Indicates the whether the port link-test is enabled or
Indicates the port's partition status, either enabled or
Indicates how the port speed is set: auto-negotiation , 10Mbps ,
Indicates whether or not the port
11