3Com 3CR17251-91 - Switch 5500G-EI Stackable Gigabit Ethernet Getting Started Manual page 72

72 C 4: C
HAPTER REATING AN
XRN S F
TACKING ABRIC
Table 19 SuperStack 4 Switch 5500 Support for XRN Distributed Fabric
Switch
Switch 5500-SI 28-Port
(3CR17151-91)
Switch 5500-SI 52-Port
(3CR17152-91)
Switch 5500-EI 28-Port
(3CR17161-91)
Switch 5500-EI 52-Port
(3CR17162-91)
Switch 5500-EI PWR
28-Port (3CR17171-91)
Switch 5500-EI PWR
52-Port (3CR17172-91)
Switch 5500-EI FX 28-Port
(3CR17181-91)
Switch 5500G-EI 24-Port
(3CR17254-91)
Switch 5500G-EI 48-Port
(3CR17255-91)
Switch 5500G-EI SFP
24-Port (3CR17259-91)
* Distributed Device Management
Stacking Switch 5500 Units
1 Ensure that the Switch units that you wish to interconnect have the latest
software agent installed. You can use the display version
command to check this.
2 Enable the 'up port' and the 'down port' on each Switch (see
operate in Fabric mode using the following CLI command. From the
System View enter fabric-port gigabitethernet 1/0/51
enable, for example.
Port used
Ports 27 (up port) and 28 (down
port) using a 1000 Mbps SFP
transceiver
Ports 51 (up port) and 52 (down
port) using a 1000 Mbps SFP
transceiver
Ports 27 (up port) and 28 (down
port) using a 1000 Mbps SFP
transceiver
Ports 51 (up port) and 52 (down
port) using a 1000 Mbps SFP
transceiver
Ports 27 (up port) and 28 (down
port) using a 1000 Mbps SFP
transceiver
Ports 51 (up port) and 52 (down
port) using a 1000 Mbps SFP
transceiver
Ports 27 (up port) and 28 (down
port) via 10/100/1000BASE-T
ports
Two dedicated stacking cable
ports (one 'up' and one 'down')
on the rear of the unit.
Two dedicated stacking cable
ports (one 'up' and one 'down')
on the rear of the unit.
Two dedicated stacking cable
ports (one 'up' and one 'down')
on the rear of the unit.
XRN support
*
Only supports DDM
Only supports DDM*
Full XRN functionality
Full XRN functionality
Full XRN functionality
Full XRN functionality
Full XRN functionality
Full XRN functionality
Full XRN functionality
Full XRN functionality
Table 19) to