Initial Start-Up; Select "Freezing" Or "Cooling - AEG ÖKO-ARCTIS 3193-4GA Operating Instructions Manual

Initial Start-Up

0 Insert plug into mains socket.
0 Press ON/OFF button.
The green stand-by display lights up. The temperature display shows
the current freezing room temperature (actual temperature).
The blinking red warning display indicates that the required storage
temperature has not yet been reached.
Within 5 minutes after the appliance has been switched on, the elec-
3
tronics initialise a self-test. The compressor does not start until after
completion of the self-test.
In the delivery state, your appliance is present in the operation mode
3
"Freezing".
If the appliance was once in operation, it restarts in the operation
mode, which was set prior to switching off.

Select "Freezing" or "Cooling"

If necessary, switch over the appliance with the following steps
between the operating modes "Freezing" and "Cooling":
0 Press temperature regulator and free it from its recessed position.
0 Hold the ON/OFF button pressed for at least 2 seconds. A peep tone
sounds.
The operation mode, in which your appliance is at the moment, is iden-
3
tifiable if the temperatures can be set above or below 0 °C.
0 Return the temperature regulator again to the retracted position.
0 Set the temperature depending upon the selected operation mode (see
the chapter "Temperature Adjustment").
Attention! If you are using the appliance as a freezing unit: Please wait
prior to putting the foodstuff to be frozen, until the freezing room
temperature has attained -18 °C, or until the red warning display goes
off.
Attention! If you are using this appliance as a cooling unit, after it has
been used as a freezing unit: Please wait until the cooling cabinet tem-
perature has reached 0 °C, before placing food to be cooled inside.
14