Your Appliance Needs Air; Housing Dimensions; Electrical Connection; Prior To Initial Start-Up - AEG SANTO C 8 16 41-5 i Operating And Installation Instructions

Your appliance needs air

For safety reasons, minimum ventila-
tion must be as shown Fig.
Attention: keep ventilation openings
clear of obstruction;

Housing Dimensions

Height
Depth
Width

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if sup-
ply voltage and current values correspond with those of the mains at the
installation location.
e.g.:
(i.e. 220 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
A correctly installed, earthed socket is required for the electrical supply. The
supply must have a fuse rating of at least 10 Amps.
If the socket is not accessible once the appliance is built in, the electrical
installation must include suitable means of isolating the appliance from the
mains (e.g. fuse, cut-out, current trip or similar with a minimum contact
separation of 3 mm).
Attention: The mains connection cable may only be replaced by a skilled
electrician. Please contact your dealer or our customer service department
for repairs.
Prior to Initial Start–Up
• Please clean the appliance interior and all accessories prior to initial start-
up (see section: "Cleaning and Care").
1580 mm
550 mm
560 mm
AC 220 ... 240 V
220 ... 240 V~
D567
50 Hz
min.
50 mm
2
200 cm
50 Hz or
min.
200 cm
2
61