Communication Format; Header Block Format (Fixed Length) - NEC X461UN - MultiSync - 46" LCD Flat Panel Display Control Manual

4. Communication Format

Header
The command packet consists of four parts, Header, Message, Check code and Delimiter.
Sequence of a typical procedure to control a monitor is as follows,
[A controller and a monitor, two-way communication composition figure]
Controller
Delimiter
Delimiter
Delimiter
Delimiter
Delimiter

4.1 Header block format (fixed length)

Reserved
SOH
'0'
st nd
1 2
st
1 byte) SOH: Start of Header
ASCII SOH (01h)
Message
Get Parameter
Check Code
Message
Get Parameter Reply
Header Message
Set Parameter
Check Code
Message
Set Parameter Reply
Header Message
Get Parameter
Check Code
Message
Get Parameter Reply
Header Message
Save Current Setting Command
Check Code
Message
Save Current Setting Command Reply
Header Message
Command
Check Code
Message
Command Reply
Header Message
Destination Source
rd th
3 4
Check Code Delimiter
Monitor
Header
Check Code
Delimiter
Header
Check Code
Delimiter
Header
Check Code
Delimiter
Header
Check Code
Delimiter
Header
Check Code
Delimiter
Header
Message
Message Message
Type Length
th th
5 6
(2/43)
The controller sends command to
get a value from the monitor that
you want to change.
The monitor replies a current value
of the requested item.
The controller sends commands to
set an adjusted value.
The monitor replies
controller for confirmation.
The controller sends command to
get a value for confirmation.
The monitor replies an adjusted
value.
The controller requests to store
the adjusted value to the monitor.
The monitor replies
controller for confirmation.
The control does not suitable for
above fixed protocol; use the
proper command for each control.
Please refer 7.Power
procedure and followings.
The monitor replies
message defined for each control.
Check code Delimiter
th
-7
to the
to the
control
a proper