Correcting the date and time
(Lite Touch Zoom 100W QD only)
Press and hold the MODE/SEL button for more
1
than 2 seconds.
When the date/time display format is Year/Month/Day, Month/Day/
Year, or Day/Month/Year, the display in correction mode turns into
Year/Month/Day, and then "Year" indicator blinks first. For Day/Hour/
Minute display, "Hour" indicator blinks first.
When the camera is on, the data will be immediately registered if the
slide cover is closed, or the Mid-roll Rewind button or a Zoom button
is pressed while the setting is in progress.
Press the ADJ button to set the blinking digit.
2
Each time you press the ADJ button, the number advances by one.
Holding the ADJ button pressed for more than 2 seconds advances the
number quickly.
3
When the blinking indicator is correctly set,
press the MODE/SEL button again so that the
next indicator blinks.
Repeat steps 2 and 3 to set all the digits. When the Year/Month/Day or
Day/Hour/Minute have been adjusted, press the MODE/SEL button to
finish the adjustment procedure. If the Year/Month/Day or Day/Hour/
Minute are all displayed correctly, adjustments has been completed.
When the battery is replaced
a"
" may be displayed on the LCD panel.
aThe date/time is not imprinted in pictures taken while "
indicated. Set the date and time following the above procedure.
MODE/SEL button
ADJ button
Additional Information
En
" is
39