Important Safety Information You MUST read these warnings carefully before installing or using the appliance. If you need assistance, contact our Customer Care Department on 08705 950950 Installation This cooker must be installed by qualified personnel, according to the manufacturer’s instructions and to the relevant British Standards.
Contents For the User Important Safety Information ... 2 Description of the Cooker ... 4 Control Panel ... 5 The Oven Cavity ... 5 Accessories ...5 Operation ... 6 Hob burners ... 6 Gas oven and Electric grill ... 7 Using the Oven ...
Description of the Cooker Cooker lid Semi-rapid burner Semi-rapid burner Rapid burner Auxiliary burner GAS OVEN & NORMAL RAPID SIMMER NORM ELECTRIC GRILL TIMER GRILL Control panel Oven door Storage drawer...
Control Panel NORMAL 1. Grill Function Pilot Light 2. Electric Ignition push button 3. Oven Light push button 4. Back left burner control knob (semi-rapid) 5. Front left burner control knob (rapid) 6. Front right burner control knob (auxiliary) 7. Back right burner control knob (semi-rapid) 8.
Operation Hob burners To light a burner, push in and turn the relevant control knob anticlockwise to maximum position. At the same time push the electric ignition button which is marked with a little spark. Then adjust the flame as required.
Gas oven and Electric grill Oven Function Control Knob Oven switched off -MAX Range of temperature regulation for gas oven Grill - The heat comes only from the top element Minute minder The minute minder will mark the end of a timed period with an acoustic alarm.
Using the Oven • Always cook with the oven door closed. • Stand clear when opening the drop down oven door. Do not allow it to fall open - support the door using the door handle, until it is fully open. •...
Using the Gas oven Before using your oven Switch the oven to MAX. and leave it to run empty for about 30 minutes to remove any unpleasant smell. During cooking, the door should be opened as little as possible to avoid heat loss, and excessive fuel consumption.
Gas Oven Cooking Charts This chart is intended as a guide only. It may be necessary to increase or decrease the temperature to suit your individual requirements. Only experience will enable you to determine the correct setting for your personal requirements.
Page 11
Gas Oven Cooking Charts This chart is intended as a guide only. It may be necessary to increase or decrease the temperature to suit your individual requirements. Only experience will enable you to determine the correct setting for your personal requirements.
Grilling Grilling must be carried out with the oven door closed. The grill pan handles must be removed from the pan. How to Use the Grill 1. Turn the oven control function knob to grill pilot light will come on. 2.
Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the cooker from the electricity supply. The Hob Top The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool.
Cleaning the Oven The oven should be kept clean at all times. A build-up of fats or other foodstuffs could result in a fire, especially in the grill pan. Cleaning materials Before using any cleaning materials on your oven, check that they are suitable and that their use is recommended by the manufacturer.
Page 15
To clean the oven shelves, soak in warm soapy water and remove stubborn marks with a well wetted soap impregnated pad. Rinse well and dry with a soft cloth. Oven lamp replacement Disconnect the appliance. Unscrew the lamp and substitute it with another suitable for higher temperature (300 C) having the following specifications: Voltage:...
Something Not Working If the appliance is not working correctly, please carry out the following checks, before contacting your local Parkinson Cowan Service Centre. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
If you require spare parts or an engineer contact your local Service Force Centre by telephoning: 08705 929 929 Your call will be routed to the Service Centre covering your post code area. The addresses of Parkinson Cowan Service Force Centres are detailed on the following pages.
Page 18
PARKINSON COWAN SERVICE FORCE To contact your local Parkinson Cowan Service Force Centre telephone 08705 929 929 CHANNEL ISLANDS GUERNSEY Guernsey Electricity PO Box 4 Vale , Guernsey Channel Islands JERSEY Jersey Electricity Company PO Box 45 Queens Road St Helier Jersey Channel Islands JE4 8NY...
Page 19
PARKINSON COWAN SERVICE FORCE To contact your local Parkinson Cowan Service Force Centre telephone 08705 929 929 MIDLANDS BIRMINGHAM 66 Birch Road East, (M18) Wyrley Road Industrial Estate Witton Birmingham B67DB BOURNE Manning Road Ind (M44) Estate Pinfold Road Bourne PE10 9HT BRIDGNORTH 1 Underhill Street...
Instructions for the Installer Technical Data Model Number: CSIG 503 W Appliance Class 2 sub class 1 and Class 1 APPLIANCE CATEGORY: 2H3+ APPLIANCE GAS SUPPLY: Natural gas G20 20mbar Dimensions Height Depth Width Oven Capacity Rear left burner (rapid)
Important Safety Requirements This appliance must be installed in accordance with the Gas Safety (Installation and Use) Regulations (current addition) and the I.E.E. Wiring Regulations. Detailed recommendations are contained in the following British Standard Codes of Practice - B.S. 6172, B.S. 5440: Part 2 and B.S. 6891: Current Editions.
Installation FO 1141 The appliance must be installed in accordance to the type X (standard EN 60335-2-6). Therefore the appliance can not be installed beside furniture higher than the cooker worktop. This cooker must only be installed by qualified personnel, according to the manufacturer’s instructions and to the relevant British Standards.
WALL FACE PENCIL LINE ON THE FLOOR PLAW VIEW OF THE COOKER FO 0179 Fig. 2 Fitting the Stability Bracket (Not supplied) If the cooker has to be installed with a flexible supply pipe, it is necessary that a stability device is fitted.
Electrical connections Any electrical work required to install this cooker should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS COOKER MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed.
Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - Turn the gas tap to the MAX position and ignite. - Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times.
Conversion from Natural to LPG Gas IMPORTANT The replacement/conversion of the gas hob should only be undertaken by a CORGI registered engineer. It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct injectors are fitted.
Page 27
Minimum level adjustment of gas oven burner After setting the oven on maximum temperature with door closed for about 10 minutes, turn the knob on minimum. To reach the thermostat by-pass screw and adjust the minimum level, act as follows: –...