Yamaha Portable Grand DGX-640 Owner's Manual page 11

2
"L"
w
6 x 70 mm
roundhead screws
3
e
6 x 30 mm roundhead screws
q
Joint
connectors
"R"
2
Attach the stand bases.
Insert the joint connectors
shown. The joint connectors have been installed
properly if you can see the screw head on the con-
nector.
NOTE
• If you put the connectors in wrong direction and want to
take them out, tap around the holes on the boards.
Attach the "L" (Left) and "R" (Right) stand bases
to the bottom of the side boards, using the screws
w
. "L" (Left) and "R" (Right) are marked on the
upper surfaces of the stand bases. If you have trou-
ble fastening the screws, use a screwdriver to rotate
the joint connectors so that the connector holes are
aligned with the screw holes on the stand bases.
3
Attach the back board.
Attach the back board, using the screws
the back-to-front orientation for the side boards.
Make sure the non-colored surface is facing down.
CAUTION
• Be careful not to drop the back board or touch the
sharp metal fittings.
NOTE
• If you have purchased an optional pedal unit, attach the
pedal unit before proceeding to the next step. Refer to the
instructions provided with your pedal unit.
Setting Up
q
into the side boards as
e
. Check
11
Owner's Manual