4.5.2
Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an
item then press <Enter> to display the sub-menu.
Advanced
Advanced Chipset Settings
WARMING: Setting wrong values in below sections may cause
system to malfunction.
North Bridge Configuration
North Bridge Chipset Configuration
Advanced
North Bridge Chipset Configuration
Memory Remap Feature
Initiate Graphic Adapter
PEG Port Control
PEG Port Force x1
Memory Remap Feature [Enabled]
Allows you to enable or disable the remapping of the overlapped PCI
memory above the total physical memory. Enable this option only when you
install 64-bit operating system. Configuration options: [Disabled] [Enabled]
Initiate Graphic Adapter [PEG/PCI]
Allows you to decide which graphics controller to use as the primary boot
device. Configuration options: [PCI/PEG] [PEG/PCI]
PEG Port Control [Auto]
Configuration options: [Auto] [Disabled]
The following item appears only when you set PEG Port Control to [Auto]
PEG Port Force x1 [Disabled]
Configuration options: [Enabled] [Disabled]
4-26
BIOS SETUP UTILITY
BIOS SETUP UTILITY
[Enabled]
[PEG/PCI]
[Auto]
[Disabled]
Configure North Bridge
features.
Enabled: Allow
remapping of
overlapped PCI memory
above the total
physical memory.
DISABLE: Do not allow
remapping of memory.
Chapter 4: BIOS setup