Asus P4R800-V Deluxe User Manual page 122

Create Stripe Raidset options
Source
Target
Create Only
Split data (Boot from IDE)
Split data (Boot from 180)
OK
Cancel
<Disk Copy Remaining Sector> Displays the remaining splitting data
6. Click OK after setting the values.
7. The following warning message appears when the operation is Split
data into RAID 0. Click Yes to continue or No to cancel.
8. A restart warning message appears after configuration is completed.
Click OK.
Refer to the SiS 180 Serial ATA User's Manual in the support CD for
details on the SiSRAID utility.
5-24
Displays the first selected disk.
All available disks except the first selected disk.
This operation destroys all data on the selected
disk and creates a clean stripe array without any
data.
This operation will split the data from the source disk
into all the selected disks. In this mode, the boot
disk may not be booted from the SiS 180 chip.
This operation is similar to "Split data into RAID 0
operation, but the boot disk may boot from the
SiS 180 chip.
Starts the array configuration.
Aborts the array configuration.
Chapter 5: Software support