System Memory; Memory Configurations - Asus P4PE-X TE User Manual

1.9

System memory

The motherboard comes with three Double Data Rate (DDR) Dual Inline Memory
Module (DIMM) sockets. These sockets support up to 2GB system memory using
184-pin unbuffered non-ECC PC3200*/2700/2100/1600 DDR DIMMs. The
following figure illustrates the location of the DDR DIMM sockets. (*
)
mode
If you wish to use a PC3200 (400MHz) DDR module, you need to install a CPU
with 800MHz FSB. Without an 800MHz FSB CPU, the DDR module can only
run at 333MHz or lower frequency.
P4PE-X/TE
P4PE-X/TE 184-Pin DDR DIMM Sockets

1.9.1 Memory configurations

You may install any DDR DIMMs with 64MB, 128MB, 256MB, 512MB, and 1GB
densities into the DIMM sockets.
1. Use only the following combinations to install DDR DIMMs. Otherwise, the
2. It is recommended to use the DIMM slots sequentially according to the
DDR DIMM1
(Rows 0&1)
SS/DS
SS/DS
*
SS - Single-sided DIMM
DS - Double-sided DIMM
1. DDR DIMM sockets 2 and 3 share the same rows, so if you install a
2. x16 Double-sided DDR DIMMs (16-bit memory chips) are not supported on
3. You may install single-sided DIMMs into DIMM2 and DIMM3 sockets at the
1-12
®
system may not boot up.
following: DIMM slot 1->DIMM slot 2 -> DIMM slot 3.
DDR DIMM2
(Rows 2&3)
DS
SS
double-sided DIMM into DIMM2 socket, you must leave DIMM3 socket
empty.
this motherboard.
same time but neither one can be x16 DDR module.
80 Pins
104 Pins
DDR DIMM3
(Rows 3&2)
None
SS
Chapter 1: Product introduction
Overclocking