Configure Vpi And Vci - D-Link DSL-2680 User Manual

Chapter 3 - Setup
Follow the instructions below to configure the virtual connection.
To configure the virtual connection, follow these steps:
1. Enter the values for the VPI and VCI given to you by your service provider.
2. Select Enable from the Virtual Circuit pull-down menu to make the connection
active. If you prefer to leave the connection inactive leave this as Disable, and
activate it when it is needed.
3. Choose the type of connection used for the virtual connection and configure the
settings according to the instructions of your service provider.
4. Click the Save Settings button to save the configuration. If you want to establish
the connection now, click the Connect button.
VPI - The Virtual Path Identifier is used with the VCI to define a dedicated circuit on the ATM network portion of the connection to the Internet and WAN. Most users
will not need to change this setting.
VCI - The Virtual Channel Identifier is used with the VPI to define a dedicated circuit on the ATM network portion of the connection to the Internet and WAN. Most
users will not need to change this setting.
Virtual Circuit - Use this to enable or disable the PVC you are currently configuring. By default, the PVC0 is set to Enable.
D-Link DSL-2680 User Manual

Configure VPI and VCI

27