Table of Contents
Advertisement
Install the water inlet hose; Select the water level
Insert the water inlet hose into the water-filling
entrance on the control panel
To dismantle the water inlet pipe,
just push the control handle as indicated in the
figure and pull it out
Select water level according to the
quantity of the laundries.
Set the water level adjusting lever
to needed line.
note: the appliance is to be connected to the water
mains using a new host-set and old hose-sets
should not be reused.
Voltage change
This washer is assembled for 220V, but can be changed from 220V to 127V.
Check your electrical source and follow the diagram below to convert voltage.
(1).
Loosen the fastening screw and take off the back cover.
(2). Unknit
the safeguard bag to expose the connectors.
(3). Detach the white connector from the green one(220V), then inlay it into the blue
one(127V).
(4). Pack all the connectors with the safeguard bag as usual and f
the back cover.
Above all the steps must be done by the special serviceman.
Warning!
Before obtaining access to terminals,all supply circuits must be disconnected.
Water level
indicator
Maximum
Max
Med
Medium
Min
Minimum
6
Water inlet hose
Water inlet
Green
Blue
White
ix it.
Then install
Advertisement
Table of Contents
