Table of Contents
Advertisement
Front Panel Functions and Operation
1. POWER: Press this button to toggle the KOD-
1000 on and off. Turning off the power on the player's
front panel, however, will not allow it to be powered
on by the remote control.
2. NUMERIC KEYS: Press these buttons to input
track selections and song numbers.
3. PLAY/PAUSE: Press this button to begin playing;
press again to pause and press it again to resume.
4. STOP: Press this button to stop playing the selec-
tion.
5. OPEN/CLOSE: Press this button to open or close
the disc tray.
6. L/R: Press this button to isolate the left or right
audio channel, or to select mono or stereo output for
DVDs and CDs.
7. DISC TRAY: To open, press OPEN/CLOSE.
Place the disc in the tray. Press OPEN/CLOSE again
or the PLAY/PAUSE button to close. The disc should
Back Panel Functions and Operation
1. ELECTRIC PLUG: An auto-detect power supply
(100-240 V, 50-60Hz) connects to alternating current.
2. VGA PORT: This port connects the KOD-1000 to
a computer monitor. The RCA Video out will con-
tinue to work if the VGA port is enabled. For more
information about using this port, see Page 7.
3. PS/2 KEYBOARD: This port connects to a com-
puter keyboard. For more information, see Page 7.
4. OPTICAL OUTPUT: This connection is used
for 5.1 surround sound (Dolby Digital and DTS). The
SETUP menu must be set for this output. See Page
22 about setting up the optical output. Microphones
play immediately.
8. DISPLAY WINDOW: Time, disc format or song
number is displayed here.
9. MENU: Press this button to display categories in
Hard Disk Drive Mode and a chapter list when play-
ing a DVD.
10. USB INTERFACE: This interface allows the
KOD-1000 to access mass storage devices such as
USB/flash/thumb drives as long as they are formatted
as FAT32 (See Page 6 for more information).
11. DIRECTION: Use these button to navigate on
screen menus.
12. MIC 1 & 2 JACKS: These jacks connect micro-
phones to the KOD-1000 through 1/4 inch plugs.
13. ENTER: Press this button to confirm selections.
14. MIC 1 & 2 VOLUME KNOBS: Use these knobs
to control the volume of the microphones.
don't work when this output is in use.
5. COAXIAL OUTPUT: This connection is used for
5.1 surround sound (Dolby Digital and DTS). The
SETUP menu must be set for this output. Micro-
phones will not work when this output is in use.
6. S-VIDEO OUTPUT: This connection is for the
s-video output. It is of better quality than the RCA
Video Output, but not as good as the component
output. See page 21 to set this output.
7. COMPONENT OUTPUT: This connection is
usually found on high definition televisions. Change
Video setting to INTERLACE-YUV before connect-
ing a component cable or no picture will show on TV.
See page 21 for more information.
4
Hide quick links:
Advertisement
Table of Contents
