Table of Contents
Advertisement
6.5.4 Removing/Replacing the Keyboard Assembly
The procedure for removing and replacing the keyboard assembly is as follows:
1.
Turn off the computer; disconnect the AC power adapter (if it is attached), and remove the
battery pack as described in Paragraph 6.5.1.
2.
Press the Cover Release Latch and open the notebook to a full 180 degree position as shown
in Figure 6-6.
3.
Slide each of the two display hinge covers out and pull upward to remove from the notebook.
Figure 6-6
Removing the Display Hinge Covers
4.
Pull up on the keyboard as shown in Figure 6-7 and disconnect the Keyboard cable connectors
J0102 and J0103.
5.
If you intend to remove further, then disconnect the Touchpad cable connector J0104.
Figure 6-7
Removing/Replacing the Keyboard Assembly
6.
Install the replacement keyboard assembly by reversing Steps 1 through 5.
Service Guide
6-7
Advertisement
Table of Contents
Troubleshooting
