Audit Trail Command Set - IBM 1352 - InfoPrint B/W Laser Printer User Manual

Audit Trail Report Command Set
&%SAR$
&%SAR
$
Marks the start of an audit record and begins a PJL job.. This command must be inserted in
the datastream after MICR Mode is entered and before the first flagged field appears. It
should be sent at the beginning of each check record.
End Audit Record
&%STORE
$
Ends the Audit Record and the PJL job (ignored if there was no Start Audit Record
Command).
Audit Report Field One
&%SQ1
d..d
$
This command identifies the data to be printed in the first column of the report. It is a
maximum of 14 characters in length. If less than 14 characters are sent, the printer fills the
field with spaces when the audit report is printed. This field is recorded in the audit report
only, it is not printed on the check.
Audit Report Field Two-MICR Line
&%SMD or &%SM7
d..d
$
This command identifies the data to be printed in the second column of the report. It is a
maximum of 40 characters in length.
Audit Report Field Three
&%SQ3
d..d
$
This command identifies the data to be printed in the third column of the report. It is a
maximum of 40 characters.
Secure MICR Printer User's Guide
July 2003
Start Audit Record
Lead in sequence
Command terminator
&%STORE$
Lead in sequence
Command terminator
&%SQ1d..d$
Lead in sequence
Data to be stored
Command terminator
&%SMDd..d$ or &%SM7d..d$
Lead in sequence
Data to be printed
Command terminator
&%SQ3d..d$
Lead in sequence
Data to be printed
Command terminator
Page 36
Section 8: Audit Trail Reports
©
Source Technologies
All rights reserved