Using Your Humidifier; Initial Setup And Operation - Hunter 36516 Owner's Manual

2
1. Remove the Hunter Evaporative Humidifier from its packaging.
®
2. Use the housing handle to carry the unit to where it will be run.
3. Place the humidifier on a hard, flat, water resistant surface. Always place the
humidifier at least six (6) inches away from walls and sources of heat.
4. Remove the tank by pulling the tank handle away from the unit until the clip
at the top releases, then pull the tank upward and out. Figure 1.
5. Turn the tank upside down and remove the tank cap by turning counter-
clockwise. Figure 2.
6. Fill the tank with clean, cool tap water and replace the tank cap by turning it
clockwise until tight.
Caution: Never fill the humidifier with hot water.
7. Turn the tank upright and place it back into the Base at an angle and then
push the tank handle towards the base until the tank clip snaps into place.
Figure 3.
8. Plug the unit into a wall outlet and start the humdifier. See "Controls" on page
6.

Using Your Humidifier

Initial Setup and Operation

©2011 Hunter Fan Company
Figure 1.
Figure 2.
Clip
Figure 3.
5