Connecting Networking Devices To Your Switch; All Switch Ports Can Automatically Negotiate Speeds At; Full- And Half-Duplex Modes To Allow Users To Attach 10Base-T And - Belkin F5D5131-16 - 10/100 Switch User Manual

Connecting Networking Devices to your Switch

Connecting your Switch to your Computers
1.
Power down all your equipment.
2.
Connect a Category 5e or 6 Ethernet cable between each computer's
network interface card (NIC) and one of the numbered ports on the front
of the Switch.
3.

All switch ports can automatically negotiate speeds at

full- and half-duplex modes to allow users to attach 10Base-T and

100Base-Tx network devices.
4.
Connect the power cord into the power socket in the rear of the Switch;
now plug the other end of the power cord into a power source (wall jack
or power strip).
6 6