Advertisement
Setup The DES-1008F,
DES-1008FL/PRO, DES-1008FR/PRO
10/100M Fast Ethernet Switch
The setup of the Switch can be performed using the following steps:
A.
Install the DES-1008F, DES-1008FL/PRO, DES-1008FR/PRO in a fairly
cool and dry place. See Technical Specification for the acceptable
operation temperature and humidity ranges.
B.
Install the Switch in a site free from strong electromagnetic source, vibration,
dust, and direct sunlight.
C.
Leave at least 10cm of space at the left and right hand side of the Switch
for ventilation.
D.
Visually inspect the DC power jack and make sure that it is fully secured to
the power adapter.
Do not stack any device on the Switch.
Mounting the Switch on a Wall
The DES-1008F, DES-1008FL/PRO, DES-1008FR/PRO can also be mounted
on a wall. Two mounting slots are provided on the bottom of the switch for this
purpose. Please make sure that the front panel is exposed in order to view the
LEDs. Please refer to the illustration below:
A.
Mounting on a cement wall
1. Mount the Nylon screw anchors into a cement wall.
2. Drive the T3 x 15L screws into the Nylon screw anchors.
3. Hook the mounting holes of the switch back on the screws; you have
completed the wall-mount.
B.
Mounting on a wood wall
1. Drive the T3 x 15 L screws into the wood wall.
2. Hook the mounting holes of the switch back on the screws; you have
completed the wall-mount.
2
(1) 3/4 inch minimum
for wood wall
(2) 3 inch minimum
for cement wall.
Advertisement
