Mounting The Switch On A Wall; Attaching The Rubber Feet - D-Link DGS-1008D User Manual

Mounting the Switch on a Wall

The DGS-1008D can also be mounted on a wall. Two mounting slots are provided on the bottom of the switch for this purpose. Please
make sure that the front panel is exposed in order to view the LEDs. Please refer to the illustration below:
A.) Mounting on a cement wall
1. Mount the Nylon screw anchors into a cement wall.
2. Drive the T3 x 15L screws into the Nylon screw anchors.
3. Hook the mounting holes of the switch back on the screws; you have completed the wall-mount.
B.) Mounting on a wood wall
1. Drive the T3 x 15 L screws into the wood wall.
2. Hook the mounting holes of the switch back on the screws; you have
completed the wall-mount.

Attaching the Rubber Feet

Use rubber feet provided. Position and apply rubber feet to the underside of the DGS-1008D Switch.
D-Link DGS-1008D Unmanaged Gigabit Ethernet Switch
Figure 2-1. Mounting the Switch to a Wall
Figure 2-2. Attaching the Rubber Feet
(1) 3/4 inch minimum
for wood wall
(2) 3 inch minimum
for cement
wall.
7