Setting Or Changing The Delay Start Timer; Load Sensing - Sensor Logic - AEG 50700 User Instructions

1. Open the door of the dishwasher. The wash programme stops.
0
2. The indicator for the programme that is currently running extinguishes.
3. Close the door. The wash programme continues.
Cancelling the wash programme
0 1. Press the button for the current wash programme and hold it pressed.
The programme indicator for the current wash programme flashes for a
few seconds and then extinguishes.
2. Release the programme button, the wash programme is cancelled.
A selected programme is only interrupted by switching off the dish-
3
washer, it is not cancelled. The wash programme is continued when the
dishwasher is switched on again.

Setting or Changing the Delay Start Timer

Using the delay start timer you can:
1. Press the ON/OFF button.
2. Press the DELAY TIMER button until the required delay (inhours) is
flashing on the multi-display.
3. Press the button for the desired wash programme. The multi-display
now displays the number of hours until the wash programme starts.
4. The wash programme starts automatically at the end of the time delay
set.
Changing the delay start:
As long as the wash programme has not started, you can change the
delay start set by pressing the DELAY TIMER button.
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes
in the upper and/or lower rack, an intelligent electronic system adjusts
the amount of water and the duration of the wash programme to the
number of dishes. By this means it is possible to wash only a few dishes
quickly and economically. At half load (6 place settings), up to 2 litres
of water and 0.2 kWh of electricity are saved.
Operating Instructions
23