14.2. The
14.2.
14.2.
14.2.
14.2.1.
14.2.1.
Gravity Acceleration Corr
Gravity Acceleration Correction
14.2.1.
14.2.1.
Gravity Acceleration Corr
Gravity Acceleration Corr
Step 1 Turn on the display.
Open the cover of the display unit.
Press and hold the
5cm, to enter the calibration mode.
Cal 0
Then
Step 2 Press the
acceleration correction mode.
Step 3 Set your local gravity acceleration using the following
switches.
∧
switch
switch
<
Step 4 Press the
Step 5 Press the
the normal weighing mode.
14.2.2.
14.2.2.
14.2.2.
14.2.2.
Preparation
Preparation
Preparation
Preparation
Step 6 Confirm the environmental conditions as follows:
Maintain a constant temperature and stable power.
Install the scale on a solid floor where there is no draft, vibration, strong magetic
fields or direct sunlight.
Consider section "4. Caution".
Step 7 Display normal weighing for at least 30 minutes to warm up the scale.
HV-WP/HW-WP Series
The Complete
Complete Calibration Procedure
The
The
Complete
Complete
switch, it is in the depth of
CAL
is displayed.
switch to enter the gravity
ZERO
Selecting the number of a figure.
Selecting a figure.
switch to store the new value.
ENTER
switch again. Then the scale returns to
CAL
Calibration Procedure
Calibration Procedure
Calibration Procedure
ction
ction
ction
Page 41
14. Calibration (Adjusting Scale)