Acai Manual Operation - A&D HC-15Ki Instruction Manual

Pcs On the
Weighing Pan
STABLE
ACAI
As you add, the ACAI
annunciator will be
ON as long as you
are in range.
3. Continue adding pieces within the ACAI range until you have reached a sample size
as large as the largest number of pieces that you will be counting.
When you have added the maximum number of pieces required, remove the
sample pieces and start your counting job.

10-3. ACAI Manual Operation

The ACAI procedure can also be controlled manually. The ACAI will not recalculate
the unit weight until the ENTER key is pressed (as long as it is at the proper time
and the guidelines in the ACAI Notes section have been followed).
The ACAI manual mode is controlled by F-Function f-02-1, set at "2".
To start ACAI manual operation, the unit weight must be registered and the samples
still on the weighing pan.
1. Add pieces within the nearest ACAI range (refer
to table in the previous section). The ACAI
annunciator will stay ON as long as you are
within ACAI range.
2. Wait until the display becomes stable and
press the ENTER key.
When the new unit weight is calculated, the
indicator will
disappear.
3. Continue adding pieces within the ACAI range until you have reached a sample size
as large as the largest number of pieces that you will be counting.
When you have added the maximum number of pieces required, remove the
sample pieces and start your counting job.
ACAI
Addition Range
10 13~26
20 23~49
30 33~70
40 43~89
50 53~106
STABLE
When you stop adding
and the display
becomes STABLE, the
ACAI annunciator will
blink for a moment
60
70
80
90
100
over 200
ACAI
After the new unit
weight is calculated,
the annunciator will
blink.
88888821
WEIGHT
8882. 3
and
38
63~122
73~138
83~152
93~166
103~299
203~492
STABLE
ACAI
disappear,
COUNT
UNIT WEIGHT
318 111. 0 00
8
ACAI