Led Indicators - Panasonic DMP-BD79 Owner's Manual

LED indicators

Error states are indicated by the INFO LED.
Confirm the following items in correspondence to the state of INFO LED on the front panel of this unit.
≥ If the state of the INFO LED does not change after performing the operations in the table below,
contact your local Panasonic dealer.
INFO LED state
Flashes 6 times
Lights up
Flashes
Flashes 3 times
28
VQT4V11
INFO LED
The remote control and this unit are using different codes.
"Remote control " is displayed on the screen.
Press and hold [OK] and the displayed number (" ") for at least 5
seconds.
The USB device is drawing too much power. Please disconnect or
remove the USB device from the unit.
The USB device may be incompatible.
The following conditions are possible:
≥ The copyright protected disc cannot be played back.
One of the devices connected to this unit (TV, amplifier, etc.) does not
support copyright protection.
≥ Temperature of this unit is hot and the unit switches to standby for
safety reasons.
Wait for about 30 minutes.
Select a position with good ventilation when installing the unit.
The disc in use cannot be played back since the copyright information is
invalid.
Description