Haier HLC22XSLW2 Important Safety Instructions Manual page 6

Precautions
1.As strong light may interfere the signals, change your
position to operate the remote controller if the television
cannot be turned on or off as you expect.
2.Keep the remote controller away from heat source
or humid area to ensure effective performance of the
remote controller.
Remote control
USB DVD
GUIDE CCD MTS/SAP CH.LIST
PICTURE AUDIO ARC FAVORITE
INPUT
7
MUTE RECALL
8
9
VOL CH
MENU EXIT
10
11
ENTER
S L E E P D S I P
12
13
OPEN/CLOSE PLAY/PAUSE STOP REPEAT
14
REV PREV NEXT
15
16
D.MENU D.CALL D.AUDIO SETUP
17
18
SEARCH ANGLE SUBTITLE PROGRAM
19
20
(For TV with DVD)
1 Power
2 USB
3 GUIDE
21
4 CCD (closed caption)
22
5 PICTURE
23
24
6 AUDIO
25
7 INPUT
8 MUTE
9 VOLUME UP/DOWN
26
0 MENU
Thumbstick (Up/Down/
A
Left/Right)
27
B SLEEP button
28
C DVD/USB PLAY/PAUSE
D DVD Open/close
29
E DVD/USB FAST FORWARD
F DVD/USB FAST REVERSE
30
G DVD CALL
H DVD MENU
31
I DVD SEARCH
J DVD ANGLE
K DVD Mode
L A Y
32
L CH.LIST
33
M MTS/SAP
34
N FAVORITE
35
36
O ARC
37
38 P Number buttons
39
Q
40
R RECALL
S CHANNEL UP/DOWN
T EXIT
U ENTER
V DISPLAY
W DVD/USB STOP
X DVD/USB REPEAT
Y DVD/USB Previous Chapter
Z DVD/USB Next Chapter
[ DVD AUDIO Mode
\ DVD SETUP
] DVD PROGRAM
` DVD SUBTITLE
3.Make sure that two AAA alkaline batteries are loaded.
The batteries must be of the same type. The batteries
must be located properly. The batteries are not
rechargeable.
4.Make sure that there is no obstacle between the
remote controller and television set.
Press to turn on and off the TV
Press to switch input source to USB in
Display the guide when you are watching analog or digital channels
Select a closed caption option
Press repeatedly to cycle through the available picture modes
Press to cycle through different sound settings
Show the input source
Switches the sound on or off
Press to adjust the volume
Press to open the on-screen menu
Allows you to navigate the on-screen menus and adjust the
system settings to your preference
Press to display the sleep timer option
Open the channel list in TV
Select MONO, STEREO, SAP in NTSC system
Open the favourite channel list in TV
Select the aspect ratio
Press to change a channel
Press to select digital channels. For example, to enter "54-3",
Press to jump back and forth between two channels
Press to scan between the last two channels, press and hold
down either +/--
Clears all on-screen displays and returns to TV viewing from any
menu
Accesses the highlighted item in the on-screen menu
Press to display the TV status information on the top of the TV screen
Haier LED HDTV/DVD
Introduction
EN-6