Removing The Keyboard; Installing The Keyboard - Dell 610D Service Manual

Back to Contents Page
Keyboard
Dell™ Latitude™ D610 Service Manual
Removing the Keyboard
Installing the Keyboard
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
Removing the Keyboard
1. Follow the instructions in "Preparing to Work Inside the
2. Remove the center control cover (see
3. Remove the two M2.5 x 5-mm screws across the top of the keyboard.
NOTICE: When you remove the keyboard, pull up gently to avoid damaging the keyboard cable.
4. Lift and rotate the keyboard clockwise 90 degrees to access the pull-tab.
5. Using the keyboard cable pull-tab, pull up to disconnect the keyboard cable connector from the keyboard connector on the system board.
NOTICE: The keycaps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and handling the
keyboard.
6. Remove the keyboard (see
NOTE: When you replace the keyboard, ensure that the keyboard tabs are completely in place to avoid scratching the palm rest.
1 M2.5 x 5-mm screws (2)
2 keyboard cable pull-tab
3 keyboard connector on system board
4 keyboard tabs (5)
5 palm rest
Installing the Keyboard
1. Connect the keyboard cable connector to the keyboard connector on the system board.
Computer."
"Removing the Center Control
"Removing the Keyboard").
Cover").