Setting Up Dialup/Isdn - Symantec 360R - Security Gateway SGS Installation Manual

Setting up Dialup/ISDN

To start the Setup Wizard
1
Install the appliance according to the instructions in
Symantec Gateway Security 300 Series appliance"
2 Browse to the appliance IP address.
By default, the IP address is 192.168.0.1.
3 In the Symantec Gateway Security 300 Series panel, select a language.
When you select a language, it is the language in which the Setup Wizard
proceeds, as well as the language which is used on the appliance.
4 Click Next.
5 In the Welcome to Symantec Gateway Security 300 Series Setup Wizard
panel, click Next.
6 Proceed to the instructions for your connection type.
"Setting up Dialup/ISDN"
■
"Configuring a DHCP connection"
■
"Configuring a DSL connection"
■
"Configuring a static IP address connection"
■
The following procedures walk you through configuring a primary dial-up
connection. For information on setting up a back-up dial-up account for
connectivity, see Symantec Gateway Security 300 Series Administrator's Guide.
Before performing these procedures, you must complete the tasks in
the Setup Wizard" on page 25.
To set up a dial-up or ISDN
1 Run the Setup Wizard.
See "Starting the Setup Wizard"
2 In the Connection Settings panel, click Dialup/ISDN.
In the Dialup or ISDN Connection panel, under User account information
and dialup numbers, do the following:
UserName
Password
Verify Password
Dial-up Telephone 1
on page 25.
on page 26.
on page 27.
on page 24.
Type the account user name.
Type the account password.
Retype the account password.
Type the dial-up telephone number.
Running the Setup Wizard
Running the Setup Wizard
"Installing the
on page 11.
on page 27.
"To start
25