Symantec 360R - Security Gateway SGS Installation Manual page 56

56 Specifications and safety
Safeguard instructions
Warning: To prevent a possible electrical shock during an electrical storm,
do not connect or disconnect cables.
Warning: To prevent a possible electrical shock from touching two surfaces
with different electrical grounds, use one hand, when possible, to connect or
disconnect signal cables.
Warning: To avoid a shock hazard, the power cord must be connected to a
properly wired and earthed receptacle.
Warning: To avoid a shock hazard, any equipment to which this product
will be attached must also be connected to properly wired receptacles.
Warning: Electrical current from power, telephone, and network cables is
hazardous.
Operating the unit in an equipment rack
■
If you plan to install the Symantec Gateway Security 300 Series in an
equipment rack, use these precautions:
Ensure the ambient temperature around the appliance (which may be
■
higher than the room temperature) are within the specified limits.
Ensure there is sufficient air flow around the unit.
■
Ensure electrical circuits are not overloaded; consider the nameplate
■
ratings of all the connected equipment and ensure you have overcurrent
protection.
Ensure the equipment is properly grounded, particularly any equipment
■
connected to a power strip.
Do not place any objects on top of the appliance.
■
Remove the protective plastic sheet from the top of the appliance.
■