Synchronizing The Wireless Keyboard Or Mouse - HP IQ524 - TouchSmart - 4 GB RAM Getting Started Manual

Synchronizing the wireless keyboard or mouse

The wireless keyboard and mouse are pre-synchronized for your convenience, to work with your
HP TouchSmart PC. They should work immediately after pulling the battery tabs, which activate the
pre-installed batteries, and turning the mouse switch on (B).
You may need to manually synchronize the wireless keyboard or mouse if they are not functioning.
To synchronize them:
Make sure the keyboard and mouse are next to the HP TouchSmart PC, within 30 cm and away from
interference from other devices.
Keyboard: Press the connect button on the bottom of the keyboard (A) for five seconds. The blue
activity LED in the bottom rear of the HP TouchSmart PC will illuminate when the synchronization
command has been received and will go off when synchronization is complete.
Mouse: Press the connect button on the bottom of the mouse (C) for five seconds. The blue activity LED
in the bottom rear of the HP TouchSmart PC will illuminate when the synchronization command has
been received and will go off when synchronization is complete.
A
If this does not work, remove and then re-insert the wireless keyboard and mouse receiver from the back of
the computer and then synchronize the keyboard and mouse again.
Towel
Getting to Know the HP TouchSmart PC
B C
11