Brother Simplicity SB7050E Operation Manual page 32

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
GETTING READY
a Turn on the machine.
b Place the bobbin on the bobbin winder shaft so
that the spring on the shaft fits into the notch
in the bobbin.
Press down on the bobbin until it snaps into
place.
a
b
a Notch
b Bobbin winder shaft spring
c
Slide the bobbin winder in the direction of the
arrow until it snaps into place.
(Start/stop button) lights up in orange.
d Pick up the spool pin and remove the spool
cap that is inserted onto the spool pin.
a
a Spool cap
b Spool pin
30
e
f
b
Place the spool of thread for the bobbin onto
the spool pin.
Slide the spool onto the pin so that the spool is
horizontal and the thread unwinds to the front
at the bottom.
Memo
Use the embroidery bobbin thread for
embroidering.
Note
If the spool is not positioned so that the
thread unwinds correctly, the thread may
become tangled around the spool pin.
Slide the spool cap onto the spool pin and
return the spool pin to its original position.
Slide the spool cap as far as possible to the right
as shown, with the rounded side on the left.
CAUTION
● If the spool or the spool cap is not
positioned correctly, the thread may
become tangled around the spool pin or
the machine may be damaged.
● Three spool cap sizes are available,
allowing you to choose a spool cap that
best fits the size of spool being used. If the
spool cap is too small for the spool being
used, the thread may catch on the slit in
the spool or the machine may be
damaged.
●