Connecting The Ac Power; Connecting The Audio Cable; Setting Up The Lcd Monitor; Power Management System - Hitachi CML175SXW User Manual

Connecting the AC Power

1. Connect the power cord to the LCD
Monitor.(See Fig. 1-3)
2. Connect the power cord to an AC power
source.
WARNING
Please install a "Surge Protector" device between the Power Cord and the electrical wall
outlet for added protection against power surges to prevent the effects of sudden voltage
variations from reaching the LCD Monitor. Sudden power surges may damage your
monitor.

Connecting the Audio Cable

1. Connect the audio cable to the " LINE OUT "
jack on your PC's audio card or to the front
panel's "AUDIO OUT" jack of your CD ROM
drive. (See Fig. 1-4)
2. Connect the other end of the audio cable to
the LCD Monitor's " LINE IN " jack.

Setting Up the LCD Monitor

1. Turn on the LCD monitor's hard power
switch, located on the back of the monitor
(See Fig. 1-5)
2. Turn on the LCD Monitor's soft power
switch, located on the bezel of the monitor.

Power Management System

This LCD Monitor complies with the VESA DPMS (version 1.0) Power Management
guidelines. The VESA DPMS provides four power saving modes through detecting a
horizontal or vertical sync. signal.
When the LCD Monitor is in power saving mode, the monitor screen will be blank and the
power LED indicator color shows.
14
Figure 1-3
Figure 1-4
Figure 1-5