Cisco 2811 - Voice Security Bundle Router Quick Start Manual page 27

Table 3 summarizes some typical WAN, LAN, and voice connections for the Cisco 2800 series routers.
Table 3 WAN, LAN, and Voice Connections
Port or Connection Port Type, Color
Ethernet RJ-45, yellow
T1/E1 WAN RJ-48C/CA81A
xCE1T1-PRI RJ-48S, tan
T3/DS3/E3 WAN BNC connector
OC3 / STM-1 WAN SC connector
Cisco serial 60-pin D-sub, blue
Cisco Smart Serial Cisco Smart compact
connector, blue
ADSL RJ-11C/CA11A,
lavender
SHDSL RJ-11C/CA11A,
lavender, RJ-14
T1/E1 digital voice RJ-48C/CA81A, tan
Analog voice FXS RJ-11, gray
Analog voice FXO RJ-11, pink
Analog voice E&M RJ-45, brown
BRI S/T WAN RJ-45/CB-1D, orange NT1 device or private integrated
(external NT1)
BRI U WAN RJ-49C/CA-A11, red ISDN network
(built-in NT1)
56/64-kbps 8-pin modular, blue
DSU/CSU
T1/FT1 DSU/CSU 8-pin modular, blue
Gigabit Ethernet LC, color according
SFP, optical to optical wavelength
Gigabit Ethernet RJ-45
SFP, copper
Cisco Modular Access Router Cable Specifications
1. See the
Connection
Ethernet hub or Ethernet switch
T1 or E1 network
External T1 CSU or other
T1 equipment
T3 network, CSU/DSU, or other
T3/DS3 equipment
OC3/STM-1 network or device
CSU/DSU and serial network or
equipment
CSU/DSU and serial network or
equipment
Network demarcation device for
service provider's DSL interface
Network demarcation device for
service provider's DSL interface
Digital PBX, ISDN network,
CSU/DSU
Telephone, fax
Central office, analog PBX
Analog PBX
network exchange (PINX)
RJ-48S interface in subrate device
or network
RJ-48C interface
1000BASE-SX, -LX, -LH, -ZX,
-CWDM
1000BASE-T
document for information about selecting these cables.
Cable
Category 5 or later Ethernet
RJ-48 T1/E1
RJ-48S to RJ-48S TE; RJ-48S to RJ-48S NT;
RJ-48S to RJ-48S T1' RJ-48S to bare
RJ-48S to BNC; RJ-48S to twinaxial cable
RJ-48S to DB-15
RJ-48S to DB-15 null
75-ohm coaxial cable
Single-mode or multimode optical fiber
Cisco serial transition cable that matches
the signaling protocol (EIA/TIA-232,
EIA/TIA-449, V.35, X.21, or EIA-530)
and the serial port operating mode (DTE
1
or DCE).
RJ-11 straight-through
RJ-11 straight-through for 2-wire
RJ-14 straight-through for 4-wire
RJ-48 T1/E1
RJ-11; RJ21 if using NM-HDA,
straight-through
RJ-45
RJ-45 straight-through
RJ-48 straight-through
RJ-48 straight-through
RJ-48 straight-through
Optical fiber as specified on applicable
data sheet
Category 5, 5e, 6 UTP
27