Mp3/Wma; Audio; Ipod (Cde-141 Only); Indication For Cd Player - Alpine CDE-141 Quick Reference Manual

Unable to fast forward or backward the CD.
• The CD has been damaged.
– Eject the CD and discard it; using a damaged CD in your unit can
cause damage to the mechanism.
CD playback sound skips due to vibration.
• Improper mounting of the unit.
– Securely re-mount the unit.
• The disc is very dirty.
– Clean the disc.
• The disc has scratches.
– Change the disc.
• The pick-up lens is dirty.
– Do not use a commercially available lens cleaner disc. Consult
your nearest Alpine dealer.
CD playback sound skips without vibration.
• The disc is dirty or scratched.
– Clean the disc; damaged disc should be replaced.
Error displays (built-in CD player only).
• Mechanical error
– Press . After the error indication disappears, insert the disc
again. If the above-mentioned solution does not solve the problem,
consult your nearest Alpine dealer.
CD-R/CD-RW playback not possible.
• Close session (finalisation) has not been performed.
– Perform finalisation and attempt playback again.

MP3/WMA

MP3/WMA is not played back.
• Writing error occurred. The MP3/WMA format is not compatible.
– Make sure the MP3/WMA has been written in a supported format.
Refer to "About MP3/WMA" on page 12, then rewrite in the
format supported by this device.

Audio

The sound is not output from the speakers.
• Unit has no output signal of the internal amplifier.
– POWER IC is switched to "ON", refer to "Connecting to an
External Amplifier (POWER IC)" on page 15.

iPod (CDE-141 only)

iPod does not play and no sound is output.
• The iPod has not been recognised.
– To reset the iPod, refer to the Owner's Manual of the iPod.

Indication for CD Player

• No CD is inserted.
– Insert a CD.
• Although a disc is inserted, "NO DISC" is displayed and the unit does
not start to play or eject the disc.
– Remove the disc by following these steps:
Press the  button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
24
-EN
• Mechanism error.
1 Press the  button and eject the CD.
If not ejecting, consult your Alpine dealer.
2 When the error indication remains after ejecting, press the 
button again.
If the error indication still does not turn off after pressing the 
button for a few times, consult your Alpine dealer.
• A sampling rate/bit rate not supported by the unit is used.
– Use a sampling rate/bit rate that is supported by the unit.

Indication for Flash Memory

• A USB device that is not supported by the unit is connected.
– Connect a USB device that is supported by the unit.
NO DEVICE
• A Flash Memory is not connected.
– Make sure the Flash Memory device is correctly connected and the
cable is not excessively bent.
• No MP3/WMA (file) is stored in the Flash Memory.
– Connect the Flash Memory device after storing songs (files).
• A sampling rate/bit rate not supported by the unit is used.
– Use a sampling rate/bit rate that is supported by the unit.
NO SUPPORT
• Text information that is not recognizable by the unit has been input.
– Use a Flash Memory device with input text information that is
supported by the unit.
• Communication error
– Turn the ignition key off, and then set to ON again.
– Check the display by reconnecting between the Flash Memory and
this unit.
• Power surge error
Excessive voltage/current is supplied to the Flash Memory.
– Try another Flash Memory, if available.