HP StorageWorks 7110 - Virtual Array Manual page 4

rbld -p
-a {on | off}
recover
No options
-s
-ps {on | off}
secure -R
-e
-d
log -p [number of events ] [-seq <start sequence number>]
-ps [number of events ] [-seq <start seqence number>]
-pc [number of events] [-seq <start seqence number>]
-clear
scsi -cdb <cdblen> <cdb bytes...> <direction> [ -cdbcrc
<cdb crc>]
[ -lun <lunId> ]
[ -data <data len> <data bytes...> [ -datacrc <data crc> ] ]
-p: Displays status/progress of a
subsystem rebuild.
-a: enables or disables autorebuild
Perform a recover process. Will ask for
user's verification to proceed.
-s: returns the recoverability status or
the disk array, as well as the status of
the recovery progress.
-ps: Recover with parity scan set to
either on or off.
-R: Resets the password to AUTORAID.
-e: enables security.
-d: disables security.
-p: Display a given number of events
starting with the specified sequence
number.
-ps: Display a given number of
significant events (stored in page2)
starting with the specified sequence
number.
-pc: Display a given number of critical
events(stored in page5) starting with the
specified sequence number.
Use only the required options with no
arguments, e.g. just "log –ps", will
display the first and last sequence
number in the log.
If only number of events is omitted, all
the corresponding events after the start
sequence number will be displayed.
If only start sequence number omitted,
the specified number of events will be
displayed starting at beginning of the
log.
-clear: Clear controller event log
direction can be: nodata|datain|dataout
Documentation about this interface is
available upon request.