Easy Setup; Speaker Settings Menu - Sony STR-DH540 Operating Instructions Manual

Easy Setup

Re-runs the Easy Setup to make the basic
settings. Follow the on-screen instructions
(page 28).

Speaker Settings menu

You can adjust each speaker manually.
You can also adjust the speaker levels after
the Auto Calibration is completed.
Note
The speaker settings are only for the current
seating position.
x Auto Calibration
Lets you perform Auto Calibration from
your seating position.
1
Follow the instructions on the TV
screen, then press
The measurement starts in five seconds.
The measurement process will take
approximately 30 seconds with a test
tone.
When the measurement ends, a beep
sounds and the screen switches.
Note
If an error code appears on the screen, see
"Message list after Auto Calibration
measurement" (page 56).
2
Select the item you want, then press
.
• Retry: Performs the Auto Calibration
again.
• Save&Exit: Save the measurement
results and exits the setting process.
• WRN Check: Displays warning
related to the measurement results. See
"Message list after Auto Calibration
measurement" (page 56).
• Exit: Exits the setting process without
saving the measurement results.
3
Note
If you reposition your speaker, we recommend
that you perform Auto Calibration again to enjoy
the surround sound.
Tips
• You can change the unit of distance in "Distance
• The size of a speaker ("Large"/"Small") is
To check the Auto Calibration
results
To check error code or warning message
obtained in "Auto Calibration" (page 55),
proceed with the following steps.
.
Select "WRN Check" in step 2 in "Auto
Calibration" (page 55) then press
If a warning message appears, check the
message and use the receiver without
change.
Or if necessary, perform Auto Calibration
again.
When "Error Code" appears
Check the error and perform Auto
Calibration again.
1
2
3
Save the measurement result.
Select "Save&Exit" in step 2.
Unit" in the Speaker Settings menu (page 58).
determined by the low frequency
characteristics. The measurement results may
vary, depending on the position of the optimizer
microphone and speakers, and the shape of the
room. It is recommended that you apply the
measurement results. However, you can change
those settings in the Speaker Settings menu.
Save the measurement results first, then try to
change the settings.
Press .
"Retry?" appears on the TV screen.
Select "Yes", then press
Repeat steps 1 to 3 in "Auto
Calibration" (page 55).
.
.
55
GB