Preventing Electrostatic Discharge - HP StorageWorks 2000fc - G2 Modular Smart Array Installation Instructions

CAUTION:
The intra-building ports of the equipment are suitable for
connection to intra-building or unexposed wiring or cabling
only. The intra-building ports of the equipment MUST NOT be
metallically connected to interfaces that connect to the Outside
Plant (OSP) or its wiring. These interfaces are designed for use
as intra-building interfaces only (Type 2 or Type 4 ports as
described in GR-1089-CORE, Issue 4) and require isolation
from the exposed OSP cabling. The addition of primary
protectors is not sufficient protection in order to connect these
interfaces metallically to OSP wiring.
Power supply information
Operation environmental specifications
• Nominal Input Voltage: -48VDC
• Rated Input Voltage: -40 VDC to -75 VDC
• Rated Input Current: 10.4A
• Rated Input Power: 500W
• Power load (single line, both lines powered): 220 watts per line,
441 watts total
• Power load (single line, one line powered): 432 watts
• Peak inrush current: 30 amps (specification limit)
• Battery Return Terminals are Isolated DC Returns (DC-I)
Replacing the power supply
In the event a power supply or its internal cooling fan fail, it must be
replaced. This should take approximately 5 minutes.
For instructions on replacing the power supply see the HP StorageWorks
2312/2324 Modular Smart Array DC power supply replacement
instructions, part number 500919-001. This document is provided with
the replacement DC power supply and can also be found at
www.hp.com/support/manuals. Under Storage, click Disk Storage
Systems, and select your product.

Preventing electrostatic discharge

To prevent damaging the system, be aware of the precautions you need
to follow when setting up the system or handling parts. A discharge of
static electricity from a finger or other conductor may damage system
boards or other static-sensitive devices. This type of damage may reduce
the life expectancy of the device.
To prevent electrostatic damage:
• Avoid hand contact by transporting and storing products in static-
safe containers.
• Keep electrostatic-sensitive parts in their containers until they arrive
at static-free workstations.
• Place parts on a grounded surface before removing them from their
containers.
• Avoid touching pins, leads, or circuitry.
• Always be properly grounded when touching a static-sensitive com-
ponent or assembly.
NOTE:
For more information on static electricity, or assistance with
product installation, contact your HP authorized reseller.
http://
Page 3