Table of Contents
Advertisement
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
4.3.4
IDE Configuration
The items in this menu allow you to set or change the configurations for the SATA
devices installed in the system. Select an item then press <Enter> if you wish to
configure the item.
Main
IDE Configuration
SATA Configuration
Configure SATA as
Hard Disk Write Protect
IDE Detect Time Out (Sec)
SATA Configuration [Enhanced]
Configuration options: [Disabled] [Compatible] [Enhanced]
Configure SATA as [IDE]
Sets the configuration for the Serial ATA connectors supported by the
Southbridge chip. Configuration options: [IDE] [RAID] [AHCI]
•
•
•
4-12
[Enhanced]
[IDE]
[Disabled]
[35]
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
If you want to use the Serial ATA hard disk drives as Parallel ATA physical
storage devices, keep the default setting [IDE].
If you want the Serial ATA hard disk drives to use the Advanced Host
Controller Interface (AHCI), set this item to [AHCI]. The AHCI allows
the onboard storage driver to enable advanced Serial ATA features that
increases storage performance on random workloads by allowing the drive
to internally optimize the order of commands.
If you want to create RAID sets with LSI MegaRAID utility, or Intel
Storage Technology from the Serial ATA hard disk drives, set this item to
[RAID].
BIOS SETUP UTILITY
Options
Disabled
Compatible
Enhanced
Select Screen
←→
Select Item
↑↓
+-
Change Option
F1
General Help
F10
Save and Exit
ESC
Exit
Matrix
®
Chapter 4: BIOS setup
Advertisement
Table of Contents
