Main Memory; Desktop Board D915Gmh Memory Configurations - Intel D915GMH Product Manual

Main Memory

NOTE
To be fully compliant with all applicable Intel
be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. If your
memory modules do not support SPD, you will see a notification to this effect on the screen at
power up. The BIOS will attempt to configure the memory controller for normal operation.
Desktop board D915GMH supports dual or single channel memory configurations defined in
Table 4.
Table 4.

Desktop Board D915GMH Memory Configurations

Memory Speed
DDR 400
DDR 333
Desktop board D915GMH supports:
•
Four 184-pin Double Data Rate (DDR) SDRAM Dual Inline Memory Module (DIMMs)
connectors with gold-plated contacts
•
Unbuffered, non-registered single or double-sided DIMMs
•
Serial Presence Detect (SPD) memory only
•
Non-ECC RAM
•
2.5 V memory
•
Memory configuration listed below:
 Up to 1.0 GB utilizing 128 Mb technology
 Up to 2.0 GB utilizing 256 Mb technology
 Up to 4.0 GB utilizing 512 Mb and 1 GB technology
NOTE
System resources (such as PCI and PCI Express) require physical memory address locations that
reduce available memory addresses above 3 GB. This may result in less than 4 GB of memory
being available to the operating system and applications.
Related Links:
Go to the following links or pages for more information about:
•
The latest list of tested memory,
•
SDRAM specifications,
•
Installing memory, page 34 in Chapter 2
Processor FSB frequency (MHz)
Pentium 4 processor 800
533
Pentium 4 processor 800
533
http://support.intel.com/support/motherboards/desktop/
http://www.intel.com/technology/memory/pcsdram/spec/
®
SDRAM memory specifications, the board should
Memory Speed Outcome (MHz)
400
400
333
333
Desktop Board Features
15