Asus SP97 User Manual page 95

IX. SOFTWARE DRIVERS
8.2 Installation
For Double Byte OS/2 Warp limitation, the installation process is a two phase
installation and can't complete the whole installation in one-time-process.
1st phase: copy files, modify "config.sys", create "SiS Install" icon then
shutdown and re-boot OS/2.
2nd phase: double clicks "SiS Install" icon to complete the installation
Before install SiS 5597/5598 OS/2 drivers, make sure:
1. Install your OS/2 system using "VGA display" option (i.e. standard VGA).
2. Start your OS/2 system.
Install SiS 5597/5598 OS/2 Warp drivers as following procedures:
1st phase:
1. Enter "OS/2 window" or "OS/2 full screen".
2. Change directory to which holds the SiS 5597/5598 OS/2 3.0 display drivers
and type SETUP <Enter>, For example, A:\OS2\DBCS.30>SETUP
3. All the Driver Files will be copied to a subdirectory C:\SISDRV and "SiS
Install" icon would be created.
4. After completing "setup" program, shutdown and re-boot OS/2.
2nd phase:
5. After re-booting OS/2, double clicks "SiS Install" icon. Then the "SiS Install"
icon would be executed automatically and "Select Screen parameters for SiS
SVGA" screen would appeared on the screen.
6. Select the desired resolution (and color) and frame rate on this screen, then
click "OK" to complete installation and "SiS Setup" icon would be created for
future change modes and frame rate usage.
7. After completing installation, shutdown and re-boot OS/2 to make your
selection effectively.
ASUS SP97-V User's Manual 95