Asus P8P67-M PRO User Manual page 42

8. Marvell
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
P8P67-M PRO Marvell
• The SATA6G_E1 (navy blue) connector is for data drives only. ATAPI device is not
• You must install Windows
• When using hot-plug and NCQ, set the Marvell Storage Controller item in the BIOS to
• Press <Ctrl> + <M> during POST to enter the Marvell RAID utility to create or delete a
• If you want to install a Windows operating system to a RAID configuration created
1-30
Serial ATA 6.0Gb/s connector (7-pin SATA6G_E1 [navy blue])
®
P8P67-M PRO
®
supported.
hard disk drives.
[AHCI Mode]. Refer to section 2.5.6 Onboard Devices Configuration for details.
RAID configuration.
using the Marvell SATA controller, you have to create a RAID driver disk using the
motherboard support DVD and load the driver during OS installation. For 32/64bit
Windows XP OS, load first the Marvell shared library driver, and then load Marvell
91xx SATA Controller Driver. For Windows Vista / Windows 7 OS, load only the
Marvell 91xx SATA Controller Driver.
SATA6G_E1
SATA 6.0 Gb/s connector
XP Service Pack 3 or later versions before using Serial ATA
®
ASUS P8P67-M PRO