Connecting A Tv And Vcr - RCA RV-3798 User Manual

Appendix A: Connecting the Receiver
TV and VCR
This connection provides
• stereo or surround sound from TV programs
broadcast in stereo
• stereo, surround sound or mono sound from a VCR
• viewing one channel on TV while recording another
channel
To use this connection, you
Should have
• (3) paired (red/white) stereo cables
• (3) single (yellow) video cables
• (2) coaxial cables
To Connect
1. Connect the cables as shown in the
diagram below.
Using This Connection
To watch TV programs
1. Turn off the VCR.
2. Press TV and tune to a channel.
To watch or play a tape on the VCR
1. Press VCR.
2. Press PLAY.
To record one program and watch another
1. Press VCR and tune to a channel.
2. Begin recording.
3. Make sure TV/VCR switch on the
VCR is set to TV.
4. Press TV and tune to a channel.
Caution: The unauthorized recording
of television programs and other
materials may infringe the rights of
others.
If your TV has more than one video
input, make sure the VCR1, LD•VCR2
and SAT buttons tune the TV to the
same channel that the receiver
monitor out is plugged into.
Refer to the TV's user's guide for
more information.
CABLE
IN
BOX
OUT
VCR
VIDEO R L
TV
L/MONO RIGHT
INPUT 1
L/MONO RIGHT
INPUT 2
L/MONO RIGHT
INPUT 3
AUDIO
DVD
RECEIVER
L
5.1
FM ANT
R
300
BAL
CENTER
L-SUR
R
REAR
R-SUR
SUB
R
WOOFER
AM ANT
AUDIO
OR ANTENNA
IN FROM ANT
IN
CH3
CH4
OUT
OUT TO TV
VIDEO S-VIDEO OUTPUT VIDEO
BRIDGED
FROM
INPUT 1
VIDEO VIDEO
FIXED
OUTPUT
VIDEO
VIDEO S-VIDEO
TV TUNER
OUTPUT
ANT A ANT B
SIGNAL
SOURCE
DVD5.1
VIDEO
IN OUT DVD/ MONITOR
VCR LD SAT OUT
VCR DVD/ SAT
IN OUT LD
L
AUDIO
L
1
AUDIO
2
IN OUT SUB WOOFER
TV CD
TAPE/MD OUT (MONO)
L/MONO RIGHT
L/MONO RIGHT
L/MONO RIGHT
37