Insert the Mounting Knobs into the threaded holes
and lightly twist by hand. Do not fully tighten the
Push down the receiver so both Mounting Knobs
are locked into the grooves, then fully tighten the
Mounting Knobs by hand.
Make sure that the cables are organized with the Cable
Cover so that the cables hang out on the same side as the
Place the bottom Mounting Knob into the hole on the
bracket, leaving the top Mounting Knob sitting above
the top hole.
To Remove the Mounting Bracket
Follow the steps in reverse order. Use a Phillips
Screwdriver to remove the Plastic Fasteners.
Cables thread out on this side