HP D6030A - NetServer - E50 Installation Manual page 18

Chapter 3
6. Insert Diskette 3 when prompted.
7. Press Enter to continue.
8. Press S to specify additional device.
9. Select Other and press Enter.
10. Insert the NetServer SCSI driver's diskette at the prompt that reads "Please
insert the diskette labeled Manufacturer - supplied hardware support disk
into drive A:"
11. Press enter to continue. Select "Hewlett-Packard 2940/78xx SCSI driver.."
and press Enter.
12. Press Enter to finish the device configuration and continue with the
installation.
13. Insert diskette 3 and follow the instructions provided on the screen by the
installer.
14. If SBS CD-ROM disk1 is not mounted you will be asked to mount it now.
15. Verify system configuration: Keyboard, Mouse etc.
16. Select The above list matches my computer and press Enter.
17. Partition disk as needed. Please note that SBS requires a lot of free space
for additional products. It is recommended that you create all drive
partitions required now. This will prevent having to change the CD-ROM
drive letter after the installation is completed.
18. If prompted, Insert the SCSI driver diskette.
19. Select the target partition for the installation and press Enter.
20. Choose Format NTFS.
Note: SBS 4.5 requires NTFS.
21. Setup begins to copy files to your hard disk.
22. When prompted insert the E 200 Driver diskette created with the HP
Startup CD.
23. Setup continues to copy more files to your hard disk. When done, remove
any diskette from the drive.
24. SBS will display a message "Restarting the computer" at the
bottom of the display.
14
Microsoft NT Small Business Server 4.5 Installation Guide