Microsoft Nt Small Business Server 4.5 Installation Guide For The Hp Netserver E 200; Section 1. Hardware Requirements For Installation; Section 2. Hp E 200 Netserver Diskette; Section 3. Perform Nt Sbs 4.5 Installation - HP D6030A - NetServer - E50 Installation Manual

3 Microsoft NT Small Business Server
4.5 Installation Guide for the HP
NetServer E 200
This document was created January 27, 2000.

Section 1. Hardware Requirements for Installation

Prepare your NetServer following the instructions in the E 200 Installation Guide.
It is recommended that you do not install any third party adapter until you verify
that the Hewlett-Packard equipment is functioning properly and you complete the
Microsoft Windows installation.

Section 2. HP E 200 NetServer Diskette

Your system includes an HP Startup CD. Boot your system from the CD and
follow the on-screen instructions to create two Drivers Diskettes and two HP
Diagtools Diskettes.
Drivers Diskette #1 – SCSI and LAN drivers
A:\SCSI – drivers for HP SCSI card
A:\NICDRV – drivers for HP LAN card
Drivers Diskette #2 – High resolution video drivers
A:\VIDEO – drivers for HP video card

Section 3. Perform NT SBS 4.5 Installation

1. Using the setup disks supplied with Windows NT SBS, insert diskette #1
to boot the system. While loading the first setup disk, when the message
"Setup is inspecting your hardware configuration..." is displayed, press F6.
2. Insert Diskette #2 when prompted.
3. Press S to skip detection of devices.
4. Press the up arrow key to select IDE CD-ROM (ATAPI 1.2)...
5. Select S to specify additional device.
13