Introduction; Before You Get Started; Control Elements; Front Panel - Behringer EUROPOWER EP2000 User Manual

5 EUROPOWER EP2000/EP4000 User Manual
1.

Introduction

Honestly, who really likes to read manuals? We know you want to get started
right away, but please read this manual carefully and keep it for future reference.
It is only after reading these instructions that you will fully understand and be
able to use all the features your EUROPOWER amplifier has to offer.
1.1

Before you get started

1.1.1 Shipment
Your EUROPOWER was carefully packed at the factory, and the packaging is
designed to protect the unit from rough handling. Nevertheless, we recommend
that you carefully examine the packaging and its contents for any signs of
physical damage, which may have occurred during transit.
If the unit is damaged, please do NOT return it to BEHRINGER,
◊
but notify your dealer and the shipping company immediately.
Otherwise, claims for damage or replacement may not be granted.
1.1.2 Initial operation
Please make sure the unit is provided with sufficient ventilation, and never place
your EUROPOWER amp on top of other heat-emanating equipment or in the
vicinity of a heater to avoid the risk of overheating.
The mains connection is made via the enclosed power cord and a standard IEC
receptacle. It meets all international safety certification requirements.
2.

Control Elements

2.1

Front panel

[ 1 ]
Fig. 2.1: Front panel control elements
Since control elements of both the EP2000 and the EP4000 are identical, we have
used the EP2000 as the model represented in the illustrations to assure simplicity.
main switch is used to power up the amp.
The
[ 1 ]
◊ Merely switching the unit off does not mean that it is fully
disconnected from the mains. When not using the unit for prolonged
periods of time, please unplug the unit's power cord from the
power outlet.
Ventilation openings are located at the front of the unit, so that hot air is
[ 2 ]
prevented from being trapped inside the unit, thus causing faulty operation
or even damage.
behringer.com
◊ Please make sure that all units have a proper ground connection.
For your own safety, never remove or disable the ground conductor
from the unit or the AC power cord.
The sound quality may diminish within the range of powerful
◊
broadcasting stations and high-frequency sources. Increase the
distance between the transmitter and the device and use shielded
cables for all connections.
1.1.3 Online registration
Please register your new BEHRINGER equipment right after your purchase
by visiting http://behringer.com and read the terms and conditions of our
warranty carefully.
Should your BEHRINGER product malfunction, it is our intention to have it
repaired as quickly as possible. To arrange for warranty service, please contact
the BEHRINGER retailer from whom the equipment was purchased. Should your
BEHRINGER dealer not be located in your vicinity, you may directly contact
one of our subsidiaries. Corresponding contact information is included in the
original equipment packaging (Global Contact Information/European Contact
Information). Should your country not be listed, please contact the distributor
nearest you. A list of distributors can be found in the support area of our website
(http://behringer.com).
Registering your purchase and equipment with us helps us process your repair
claims more quickly and efficiently.
Thank you for your cooperation!
[ 2 ] [ 3 ] [ 4 ]
The cliP leD lights up when the signal is distorted. Should distortion occur,
[ 3 ]
reduce the input level, so that the CLIP LED stops lighting up.
siGnal leD lights up as long as a signal is present at the input.
The
[ 4 ]
The Gain control (channels 1 and 2) is used for setting up the input gain.
[ 5 ]
The PoweR leD lights up as soon as the unit is
[ 6 ]
powered up.
[ 5 ] [ 6 ]