Installation; Rack Mounting; Audio Connections; Cabling With Jack Cables - Behringer Sonic Ultramizer SU9920 User Manual

4. INSTALLATION

4.1 Rack mounting

The BEHRINGER SONIC ULTRAMIZER SU9920 requires 1U
for installation in a 19-inch rack. Please make sure that you
leave around 10cm for the rear connections. For installation of
the unit in a rack please use M6 machine screws and nuts.

4.2 Audio connections

There are various ways to integrate the SU9920 into your setup.
Depending on the application you will need different connecting
cables, and these will be discussed in the following section.

4.2.1 Cabling with jack cables

To operate the SU9920 in series with other equipment, you will
need standard commercial ¼'' jack cables, often referred to as
instrument cables or patch cables.
These cables have a ¼" TS jack plug at each end. Connect the
inputs of the equipment with the corresponding outputs of each
of the other devices.
Fig. 4.1: Unbalanced 1/4" TS jack plugs
If your other equipment has balanced inputs, use a balanced
switched cable with two stereo jack plugs at the balanced outputs
of the SU9920. These cables provide a high level of security
against interference signals such as noise interference from
power cables, and they should be used for all long cable routes.
Fig. 4.2: Balanced 1/4" TRS jack plugs
SONIC ULTRAMIZER SU9920
Alternatively, you can use professional XLR cables with an XLR
socket on one side and an XLR plug on the other side. This
cable connection is the most reliable both electrically and
mechanically.
Figure 4.3: Balanced XLR plug

4.2.2 Connection with insert cables

Please use standard insert cables equipped with 1/4'' connectors
to connect the SONIC ULTRAMIZER to the insert path of a
mixing console. These Y cables have two 1/4" TS connectors at
one end, and one 1/4" TRS connector at the other. Connect the
plug marked "Send" to the INPUT L jack on the effects unit.
Connect the "Return" plug to the OUTPUT L jack on the device.
Connect the TRS connector to the insert jack of the channel
strip on the mixing console. Use two insert cables for stereo
sub-groups and main-mix inserts. The second cable must be
connected to the INPUT/OUTPUT R jacks of the SU9920.
Fig. 4.4: Insert cable with one ¼" TRS (tip-ring-sleeve) jack
plug on one end and two ¼" TS (tip-sleevel) jack plugs on the
4. INSTALLATION
other end.
9