Sanyo XF42 - PLC XGA LCD Projector Owner's Manual page 14

CONNECTING PROJECTOR
SERIAL PORT
IN TERMINAL
If you control a projector by computer,
you must connect a cable (not provided)
from your computer to this terminal.
SERIAL PORT
OUT TERMINAL
This terminal outputs signal
from SERIAL PORT IN. More
than two projectors can be
controlled with one computer
by connecting SERIAL PORT
IN. of another projector to this
terminal.
R/C JACK
When using Wired / Wireless Remote
Control Unit as Wired Remote
Control, Connect Wired Remote
Control Unit to this jack with Remote
Control Cable (not supplied).
(Refer to page 19.)
PROJECTOR ID SETTING
This feature allows users to set serial communication configuration
(Projector ID) when connecting several projectors via the RS-232C
terminal (serial port) of the projector.
1 Press the AUTO PC ADJ. button on the projector or on the remote
control Unit for 10 seconds. Projector ID appears on the screen.
2 Press POINT LEFT/RIGHT button to adjust the Projector ID.
3
Press POWER ON-OFF button to set the Projector ID completely.
● Projector ID ... 1 - 999. (Factory default setting : Projector ID 1)
14
SERIAL PORT IN
SERIAL PORT OUT
R/Pr
R/C JACK USB
AUDIO OUT
R L
RESET
(MONO)
This projector uses a micro processor to control unit.
Occasionally, micro processor may malfunction and
need to be reset. This can be done by pressing
RESET button with a pen, which will shut down and
restart unit. Do not use RESET function excessively.
AUDIO OUTPUT JACKS
Connect an external audio
amplifier to these jacks.
(Refer to P15, 16.)
USB PORT (Series B)
This port is used to service this
projector.
Connect USB port of computer to this
port.
AUDIO
DVI
R
(MONO)
AUDIO
G/Y B/Pb H/HV V
R
(MONO)
AUDIO
ANALOG RGB
R
(MONO)
RESET BUTTON
Projector ID 1
CONTROL PORT
L
CONTROL PORT
L
CONTROL PORT
L