Known Issues; Blank; Server; Firmware - HP StorageWorks 2/140 - Director Switch Release Note

Known Issues

This section describes the known issues related to HAFM software.
Link Incident Alerts Do Not Display in Port List View
Link Incident alerts (yellow triangle) do not display in the Alert column of the
table displayed in the Product Manager Port List view for any of the managed
Edge Switch or Director products. All other link incident alerts function normally.
This will be corrected in a future release of HAFM.
Attached Ports/Nodes Panel May Be Blank When Editing a Zone
Occasionally the Attached ports/nodes panel on the left of the HAFM Modify
Zone window may be blank when first opened to edit a zone. Selecting another
fabric from the Fabric drop-down list will activate the panel to display attached
ports and nodes.
Port Pop-up Menu May Be Blank
Occasionally when a right-click is applied to the graphic display of a port in the
Port Card view for a Director 2/140 port card, the pop-up menu may be blank. If
this occurs, perform an additional right-click to the graphic display of the port to
view the contents of the pop-up menu. Alternatively, you can choose the desired
port with a left-click, and then choose Product > Port on the menu bar.
Open Systems Management Server
Under the HAFM Product Manager > Hardware View menus, the Configure >
Management Server. . .menu option will result in a pop-up dialog. This dialog
states "This feature has not been installed. Please
contact your sales representative." This feature is not currently
available.
Using the Same Firmware
All switches and directors managed by HAFM should have the same FW level
installed—whether 1 Gbps or 2 Gbps capable.
HA-Fabric Manager Release Notes
Known Issues
7